Install The Elevator & Rudder Servos - GREAT PLANES Performance Reactor Instruction Manual

❏
3. Use 30-minute epoxy to glue your hinges in place.
Remember to align them and to defl ect the rudder both ways
when you install it.
❏
4. Use tape to hold your rudder in place while the
epoxy cures.
Install the Elevator & Rudder Servos
For the elevator and rudder servos, we recommend that you
use Futaba 9155 digital servos. For the elevators only, you
can use a metal geared servo with a minimum 100 oz-in [7.2
kg-cm] torque rating but you should expect a slower response
and control blow-back at higher speeds. Note: You must use
a servo with a minimum 150 oz-in [11 kg-cm] torque rating for
the rudder.
❏
1. Trim the covering from the elevator servo bay on the
right side of the fuselage as shown.
❏
2. Trim the covering from the elevator and rudder servo
bays on the left side of the fuselage.
❏
3. Attach a 36" [914mm] servo lead extension to the three
tail servos. If you anticipate mounting your receiver in the
aft-most equipment tray, you may use shorter servo lead
extensions.
❏
4. Fit your rudder and elevator servos in place. Route the
wires under the formers as shown.
15