Radio Installation; Radio System Installation - Gas Engine - GREAT PLANES Performance Reactor Instruction Manual

RADIO INSTALLATION

Radio System Installation – Gas Engine
❏
1. Prepare an ignition switch plate as you did earlier.
❏
2. Install the ignition switch plate on the model using
epoxy. A cutout for the switch plate is provided in the left and
right rear fuselage. You may choose either location.
❏
3. Tack down the covering over the switch plate using a
covering iron set to a low temperature.
❏
4. Trim the covering from over the switch plate holes and
install the ignition switch and charge jack.
❏
5. Locate the aft equipment tray, the tray doubler and the
two side rails. Glue the tray doubler to the bottom of the tray.
Align the tabs on each rail with the corresponding slots in the
fuselage and glue each rail in place as shown.
❏
6. Position the aft equipment tray in the aft bay and use a
1/16" [1.6mm] drill bit to drill six pilot holes through the side rails.
Harden the holes with thin CA. Use six #2 x 3/8" sheet metal
screws with six #2 washers to attach the aft equipment tray.
28