Wing Installation - GREAT PLANES Performance Reactor Instruction Manual

❏
9. Temporarily fi t the canopy and hatch. Fit the cowl once
again, making sure to slide it back until the centering tool
contacts the drive washer. Use a 1/16" [1.6mm] drill bit to
make four 1/2" [13mm] deep holes in the fuselage sides (two
per side). Drill them so that they are 1/2" [13mm] from the
rear edge of the cowl. Apply thin CA to the holes to harden
the wood.
❏
10. Locate the four 9mm wooden reinforcement discs.
Center them over the screw holes you drilled in the cowl.
Glue them into position. Remove the cowl centering tool
from the cowl.
❏
11. Use four #4 x 1/2" [13mm] sheet metal screws along
with four Dubro #4 nylon washers to install your cowl.

Wing Installation

❏
1. Trim the covering from the fuselage sides in the following
locations: four canopy screw holes, two wing tube holes, four
wing bolt holes, two TE wing dowel holes, and two servo
wire holes.
❏
2. Locate the 24-1/2" [620mm] wing tube and slide it into
the fuselage.
❏
3. Pull the aileron servo leads into the fuselage and install the
wings using four 1/4" x 1" [6.4 x 25mm] nylon wing bolts. Connect
the aileron servo leads to the Y-harnesses on your receiver.
36