Install The Rudder And Elevator Servos - GREAT PLANES Factor 30cc Instruction Manual

Install the Rudder and Elevator Servos

❏
1. Make a battery strap from the supplied hook and loop
material.
❏
2. Wrap the receiver in foam and secure it to the receiver
tray with a hook and loop strap.
❏
3. Install the rudder servo and plug it into the receiver.
Switch on the transmitter and temporarily plug the receiver
battery into the receiver.
❏
4. Install and center the rudder servo arm.
❏
5. Cut the 110" [2800mm] pull-pull cable in half.
❏
6. Install a 4-40 threaded coupler to one end of both pull-
pull cables as shown.
❏
7. Install a 4-40 nut and threaded clevis on the coupler.
❏
8. Insert the pull-pull cables into the guide tubes. Attach
the clevises to the servo arm.
12