GREAT PLANES Performance Reactor Instruction Manual page 20

threadlocking compound to the screw threads and install the
4-40 nut using a #4 washer and lock washer.
❏
13. Thread a 2-56 nylon ball link socket onto pushrod A
as shown and attach it to the choke arm.
❏
14. Locate the wood parts and build the fuel fi ller mount as
shown. Fuelproof the fi ller mount with a thin layer of epoxy.
❏
15. Turn the model over. Use epoxy to glue the fuel fi ller
mount to the exhaust tunnel. Use sandpaper to roughen the
surface to which the fuel fi ller mount will adhere.
❏
16. Locate the switch plate that fi ts your brand of radio
switch. Four plates are supplied: two Futaba switch & Ernst
charge jacks and two Hobbico heavy-duty & Ernst charge
jacks. Fit your switch and charge jack to the plate and use a
pen or pencil to draw an outline of the switch and jack onto the
back side of the plate. Remove the switch and charge jack.
❏
17. Use two 7 x 22mm and two 6 x 29mm sticks to make
a fl ange for the charge plate.
❏
18. Install the switch plate on the model using epoxy to
attach it. There are two forward locations reserved for the gas
engine's ignition module. We chose the one on the left side.
❏
19. Tack down the covering over the switch plate using a
covering iron set to a low temperature.
20