Valves Adjustment; Spark Arrester - Can-Am DS 650 X Operator's Manual

Squeeze foam to remove excess wa-
ter. Let dry air filter and foam thor-
oughly.
NOTE: Slight dust may be cleaned us-
ing a low-pressure airgun. Blow com-
pressed air backward of operating air
flow.
If air filter element or foam is dirty,
replace with a new one.
When the filter is dried, re-oil with air
filter oil (P/N 219 700 340) or an equiv-
alent.
Installation
Properly reinstall removed parts in the
reverse order of their removal.

Valves Adjustment

See an authorized Can-Am dealer for
valves adjustment.
Insufficient clearance will cause loss
of power and possibly damage the
valves. Excessive
cause noise.

Spark Arrester

The muffler must be periodically
purged of accumulated carbon. See
the MAINTENANCE CHART.
Removal
WARNING
Never run engine in an enclosed
area. Never perform this opera-
tion immediately after the engine
has been run because exhaust sys-
tem is very hot. Make sure that
there are no combustible materi-
als in the area. Wear eye protec-
tion and gloves. Never stand be-
hind the vehicle while purging ex-
haust system. Respect all applica-
ble laws and regulations.
_____________________
100
clearance will
Remove:
– the screws retaining the spark ar-
rester to the muffler
1
V02C06Y
1. Screws
2. Spark arrester
– spark arrester and sealant joint
2
1
V02C07Y
1. Spark arrester
2. Sealant joint
3. Muffler
– inner grill with wool.
Remove all carbon deposit in the muf-
fler.
Remove carbon deposits from the
spark arrester using a brush.
NOTE: Use a soft brush and be careful
to avoid damaging spark arrester.
1
2
3