Can-Am DS 650 X Operator's Manual page 42

• Activate the brake lever and brake
pedal to make sure the brakes fully
apply. They must fully return when
released.
• Check all brake line fittings for tight-
ness and against leaks.
• Whit parking brake correctly ap-
plied, activate the clutch lever. It
must fully return when released.
• Check drive chain for adjustment
and lubrication.
• Check sprockets for wear and dam-
ages.
• Check tightening of rear axle fasten-
ers.
• Check swing arm, if any lateral play
is detected DO NOT USE THE VE-
HICLE.
• Check fuel, oil and coolant levels.
• Check for oil leaks on the engine, oil
tank and transmission.
• Ensure fuel valve is in fully open
position (ON).
• Clean headlamp and taillight.
• Ensure seat is properly latched.
• If you transport cargo, respect load
capacity. Ensure cargo is properly
secured to the vehicle.
• Look and feel for loose parts while
engine is off. Check fasteners.
• Ensure the path of travel is free of
persons and obstacles.
• Check operation of ignition switch,
engine start button, engine stop
switch and headlamp switch.
• Start engine, remove parking brake
and drive forward slowly a few feet
then apply all brakes individually to
test them.
Correct any problem you may have
found before riding. See an autho-
rized Can-Am dealer as necessary.
___________
40 SAFETY INFORMATION
___________