Air Filter - Can-Am DS 650 X Operator's Manual

1
V02A0CY
1. Air filter housing
2. Drain tube
3. Clamp
NOTE: If vehicle is used in dusty ar-
eas, inspect more frequently than
specified in MAINTENANCE CHART.
If liquid/deposits are found, squeeze
and remove the clamp. Pull drain
tubes out then empty it.
CAUTION: Do not start engine
when liquid or deposits are found
in the drain tubes.
When liquid/deposits are found, the
air filter must be inspected/dried/
replaced depending on its condition.
Remove air filter as explained below.

Air Filter

Removal
CAUTION: Never remove or mod-
ify any component in the air fil-
ter housing. Always use genuine
parts or suitable equivalent when
replacing air filter and foam. The
engine carburetion is calibrated
to operate specifically with these
components.
performance degradation or dam-
age can occur.
Remove seat.
3 2
Otherwise, engine
Release latches and remove air filter
box cover.
V02A0DY
1. Latches
2. Air filter box cover
Remove screw driver cap by pushing
it inside of air filter housing.
Loosen clamp and remove filter.
Remove foam.
V02A0ZY
1. Clamp
2. Air filter and foam
3. Screw driver cap
Pour air filter cleaner (P/N 219 700
341) or an equivalent into a bucket.
Put the filter in to soak.
While filter soaks, clean inside of air
filter housing.
Rinse air filter and foam with warm
water.
_____________________
1
2
3 1
2
99