Air Filter Housing Draining; Air Filter - Can-Am DS 250 Operator's Manual

Check the level in the coolant reservoir
and refill if necessary.
Run engine at idle with the radiator
cap off. Slowly add additional coolant
if necessary.
At this point, wait until engine reach-
es normal operating temperature. De-
press the throttle lever two or three
times; then add coolant if required.
Install radiator cap. Inspect all connec-
tions for leaks and check coolant level
in the reservoir.

Air Filter Housing Draining

CAUTION: Never remove or mod-
ify any component in the air filter
housing. The engine carburetion
is calibrated to operate specifically
with these components.
wise, engine performance degra-
dation or damage can occur.
Periodically inspect air filter housing
drain tube for liquid or deposits.
vmo2006-014-044_a
TYPICAL
1. Air filter housing
2. Drain tube
3. Clamp
NOTE: If vehicle is used in dusty area,
inspect more frequently than specified
in MAINTENANCE CHART.
If liquid/deposits are found, squeeze
and remove the clamp. Pull drain tube
out and empty it.
CAUTION: Do not start engine
when liquid/deposits are found
in the drain tube.
When
the
ed/dried/replaced depending on its
condition.

Air Filter

Removal
CAUTION: Never remove or mod-
ify any component in the air filter
housing. The engine carburetion
is calibrated to operate specifically
with these components.
wise, engine performance degra-
dation or damage can occur.
Remove seat.
Other-
Release clamps and remove air filter
housing cover.
vmo2006-014-045_a
1. Air filter housing cover
Loosen clamp and remove retaining
screw, then remove air filter.
_____________________
liquid/deposits
air filter must
are found,
be inspect-
Other-
103