Multifunction Switch - Can-Am DS 70 Operator's Manual

WARNING
Before operating the vehicle in re-
verse, ensure the path behind is
clear of obstacles or bystanders.
BRP recommends that you remain
seated. Avoid standing up. Your
weight could shift forward against
the throttle lever causing an un-
expected acceleration and loss of
control.

6) Multifunction Switch

The multifunction switch is located on
the LH side of the handlebar.
The controls located on the multifunc-
tion switch are:
vmo2009-004-005_a
1. Emergency engine stop switch
2. Engine start button
3. Choke lever
Emergency Engine Stop Switch
This switch can be used to stop the en-
gine, and as an emergency control.
While reading this Operator's Guide, remember that:
Indicates a potential hazard that, if not avoided, could result in serious
injury or death.
CONTROLS/INSTRUMENTS/EQUIPMENT
NOTE: While the engine can be
stopped by turning the ignition key
to the OFF position, we recommend
the engine be stopped by setting the
emergency engine stop switch to the
STOP position.
To stop engine, fully release throttle
lever, then set the emergency engine
stop switch to the STOP position.
vmo2009-004-005_e
TYPICAL - EMERGENCY ENGINE STOP
SWITCH
1. STOP position
2. RUN position
Engine Start Button
To start engine, place the emergency
engine stop switch to the RUN posi-
tion.
Press and hold LH brake lever.
Press and hold the engine start button.
Release immediately after engine is
started.
WARNING
_______________
63