Steering System; Steering System; Maintenance Procedures (Cont'd) - Can-Am DS 70 Operator's Manual

Wheel Bearing Condition
Push and pull on the top of each wheel
to check for free play. See an autho-
rized Can-Am dealer if any free play is
felt.
TYPICAL
Wheel Removal and Installation
Loosen but do not remove wheel nuts.
Lift vehicle and place a support under
vehicle. Remove wheel nuts, then re-
move wheel.
At installation, it is recommended
to apply anti-seize lubricant on the
threads of the wheel mounting studs.
Gently tighten nuts in a criss-cross
sequence, then apply the specified
torque.
WHEEL NUT TORQUE
FRONT AND
REAR
40 N•m ± 4 N•m
(30 lbf•ft ± 3 lbf•ft)
_______________
MAINTENANCE PROCEDURES

Steering System

Front Knuckle Lubrication
DS 70 and DS 90
Lubricate front knuckles. Use SUS-
PENSION GREASE (P/N 293 550 033)
or an equivalent. The knuckle is fitted
with a grease fitting.
vmo2008-008-037_a
TYPICAL
1. Grease fitting
99