Display Of Values; Opearating Mode; Operating Mode - DeDietrich 310 ECO Series Installation And Operating Manual

11.3 Display of value
The display has only two digits available therefore values over this are displayed as followed:
▪
Values from 00 to 99 will be indicated without any decimals points.
▪
Values from 100 to 199 will be indicated by a dot between both digits e.g.
▪
Values from 200 to 299 will be indicated by a dot behind every digit e.g.
▪
Value over 300 will be indicated by showing the thousands, hundreds, tens and units in separate
alternating pairs. (see section 12.2 and 12.5)
▪
Negative values (for instance when using an external sensor or when sensors are not connected) will be
indicated by a dot behind the last digit, e.g.  indicates -10.

12.0 OPERATING MODE


12.1 Operating mode (
During normal operation the code-display show the status (position in cycle) of the boiler, with the
indicating the actual flow temperature.
The digits or letters in the code-display have the following meaning:
Code Description

Standby, there is no heat demand

Pre-ventilation (pre-purge time 30 seconds, post purge time 3 seconds)

Trial for ignition

Burner firing and flame detected

N/a

Waiting mode, startup check, air sensor LDs sufficient pressure

Control stop (burner off + post purge)
a) Flow temperature T1 > set point 9°F [+5°C]
b) Flow temperature T1 > desired set point modulating control 9°F [+5°C]
c) flow temperature T1 > parameter 
d) Difference flow T1 and return T2 > 10°C (factory setting) Starting condition is ≤ 10°C

End of heating demand, pump post purge. During cycling prevention delay-time the boiler will
remain in state and will not react to heat demand.

N/a

Shut-off mode (see section 12.4)

Forced full load (HIGH)

Forced part load (LOW)

Gas leakage control
 Burner cooling
Table 08
)
48
De Dietrich Gas 310/610 ECO
 =100, =110, =199
= for 200, =210, =299

-display