Oil/gas-fired near-condensing hot water boiler (86 pages)
Summary of Contents for DeDietrich GT 210 A
Page 1
GT 210 A English Oil-Gas Fired Hot Water Boiler 11/03/09 Installation & Operating Manual Please Read & Save this Manual for Future Reference Warning: Notice: Before putting the boiler into operation read this manual This manual must be retained for future reference. Improper carefully.
Page 2
Never all flue gas to the outside in a safe and burn garbage or paper in the unit, and effective manner. never leave combustible materials in the vicinity of the boiler. GT 210 A 08/0121/08/06 - 94863106 - 82274096E...
DR 84 DR 85 DR 86 DR 87 DR 88 Control panel DR 90 DR 90 DR 90 DR 90 DR 90 Casing DR 74 DR 75 DR 76 DR 77 DR 78 GT 210 A 21/08/06 - 94863106 - 82274096E...
D** = OD Dimension will for breeching connection only actual vent diameter sizing will depend on specific vent application and code requirements. (1) = Adjustable hot water tank feet for leveling, minimum height =1 3/16 inch, adjustable from 1 3/16 to 2 1/2 inch. GT 210 A 01/08/08 - 82274096F...
MLS horizontal domestic hot water tank. The two 3/4” or 1” pipes are shown are not supplied with the package BG45, they are supplied by others. 3/4"-1" 01/08/08 - 82274096F GT 210 A...
Level as shown in the drawing by means of the four adjustable feet (supplied in the bag of fasteners of the casing) put in place while assembling the boiler. (1) basic height 1 adjustment range: 1 3 /8 (1) 4 Water connection GT 210 A 21/08/06 - 94863106 - 82274096E...
National and local codes 7 /16 Ø drilling (3) 1 /4 Ø cut-out 12" 4 M8 Ø holes on 3 /16 15 /16 Ø 11 /16 4 markings on 6 Ø 3 /8 GT 210 A 21/08/06 - 94863106 - 82274096E...
Page 10
Venting 3. Boiler Venting & Chimney General Caution & Warning: It is advised and recommended that the heating contractor-professional apply vent materials that are approved and agency listed. Installation of any venting must follow all local codes in conjunction with vent manufacturer instructions and appliance manufacturer instructions.
Page 11
The P-trap assembly must be properly filled with water to avoid escape of flue gas emissions. The flue gas condensation may require neutralization prior to entering the drain. GT 210 A 21/08/06 - 94863106 - 82274096E...
Page 12
3.2 Boiler Venting – Category III & IV Vent Systems Typical Layouts and Requirements. Caution & Warning: Improperly sealed venting system could result in carbon monoxide [CO] poisoning; ensure adequate support and fastening of the system. Ensure venting can safely exhaust all flue gases outside in an effective manner. These systems must operate under a positive vent pressure condition that is stable.
Page 13
The P-trap assembly must be properly filled with water to avoid escape of flue gas emissions. The flue gas condensation may require neutralization prior to entering the drain. GT 210 A 21/08/06 - 94863106 - 82274096E...
Page 14
12” vent straight vent pipe [x3] = 3 ft. E bow 90° [x1] = 10 ft. Termination TEE [x1] = 0 ft. Length [equivalent] = 23 ft. GT 210 A Series Boiler Oil-Gas [∆p] Pressure switch Model Connection Vent ø Setting [inches w.c.] ø...
Page 15
Less than 1 ft. from soffit of the roof the flue gases. Less than 3 ft. from any building corner or L shape structure WARNING-CAUTION Consult Local Codes & Authorities for other Requirements not mentioned GT 210 A 21/08/06 - 94863106 - 82274096E...
11/2 • put back the convection accelerators • close the door and put back the front panel. Refer to the instructions supplied with the burner for burner maintenance. 21/08/06 - 94863106 - 82274096E GT 210 A...
First digit = Approved packed boiler = A or Unapproved packaged boiler = U 4 digits = boiler series 4 digits = boiler model and control 2 digits = fuel type 03 = All 2 digits = year of manufacture last 6 digits = production GT 210 A 21/08/06 - 94863106 - 82274096E...
Spare parts - GT 210 A PR82274096E When ordering spare parts, do not forget to state the code number given opposite the description of the required part in the liste. BOILER BODY 8227N154 21/08/06 - 94863106 - 82274096E GT 210 A...
Page 20
Adjustable foot 9532-5027 Two-pole green On/Off switch 9430-5027 Coating material for nipple (300 g) 8500-0034 STB Test switch 5/16 9696-0225 long brush 9532-5103 Reversing switch 9696-0226 long brush 9654-7019 10 A fuse GT 210 A 21/08/06 - 94863106 - 82274096E...
Page 21
30 - 90° C setting thermostat 8218-8973 Setting buttons + pins 8536-5155 GM flat thermometer 8199-4906 CP electrical circuit 8227-4908 Sensor wiring 8199-8984 Fasteners + accessories for control panel 9536-2632 Hour run meter 100/130V 21/08/06 - 94863106 - 82274096E GT 210 A...
Page 22
Bp 30 – 57, RUE DE LA Gare F – 67580 MERTZWILLER Tel: +33/3/88/80/27/00 – Fax: +33/3 88 80 27 99 Ni IRC : 347 555 559 RCS STRASBOURG www.dedietrich-thermique.com DDR AMERICAS INC In Canada: In USA or South America: 1090 Fountain St., Unit #10...