Management > Sntp; Access Control > Services - NetComm NB9 User Giude

Management > SNTP
The SNTP option under Management menu configures the NB9/NB9W's time automatically by
synchronizing with Internet time servers.
Note: The NB9/NB9W is configured to Australian EST by default.
Tick the corresponding box displayed on the screen. Then click Save/Apply.
Access Control > Services
The Services Option limits or enables selective access via the LAN or WAN via the following
services:
Enable the service by checking the corresponding box and clicking SAVE/APPLY. You will note
that all services are enabled for LAN clients and disabled for WAN clients by default.
CAUTION: If you disable HTTP access from the LAN then you may not be able to
open the NB9/NB9W in your Web Browser!
EXAMPLE 1:
EXAMPLE 2:
NB9/NB9W ADSL2+ VoIP Router
YML790 Rev1
You need to access your NB9/NB9W via the Internet from a remote
location through a Web browser. Method: enable WAN access for HTTP
and click Save and Apply. Then enter the address http://[WAN_IP_NB9/
NB9W] in the browser address bar of the remote machine.
Assume that you already have a web server on your LAN behind the
NB9W that people connect to from the Internet. You have entered a 'Port
Forwarding' entry that forwards incoming traffic on the WAN on port 80
to the LAN IP of the web server on port 80 (default for HTTP traffic). If
you enable HTTP WAN access to the NB9/NB9W you will be notified
that the default port to access the NB9/NB9W has been updated to port
8080. Therefore, your web server will not need to be reconfigured, and
you can access your NB9/NB9W on the WAN side using address http://
WAN_IP_OF_NB9/NB9W:8080. The same applies for other services
that use conflicting ports setup in your NB9/NB9W.
47