Connecting The Cables - NetComm NB9 User Giude

1. Connecting the Cables

Note: If you wish to link to the NB9W wirelessly at the outset, see Establishing
a Wireless Connection below.
1. Connect your PC using Ethernet cable to one of the LAN ports of your NB9/NB9W;
2. Connect the POTS pass-through line ;
i. Connect POTS telephone line FROM telephone wall-socket TO rear port on splitter
called LINE;
ii. Connect one end of the NB9/NB9W's RJ11 (telephone) cable to PHONE port of the
splitter;
iii. Connect the other end to the LINE port on NB9/NB9W;
3. Connect the ADLS service - connect one end of the second accompanying RJ11 cable to
the ADSL port of the splitter and connect the other end to the ADSL port of the NB9/
NB9W;
4. Connect the power cable to the Power socket and plug into a power source;
5. Switch your NB9/NB9W on using the switch on the rear of the device;
6. Switch on your PC.
Make sure the LAN LED (light) on your NB9/NB9W is on, which indicates that network function is
active.
Note that the pass-through service is provided as a back-up and that calls made through this line are
not the same VoIP calls and will be subject to normal telecommunications charges.
The next section explains how to establish your ADSL connection to the Internet.
14
YML790 Rev1
NB9/NB9W ADSL2+ VoIP Router