Advanced
Advanced > WAN
Clicking on the 'Advanced' menu displays the following:
This screen provides a summary of the current WAN interfaces you have configured. If you
have connected the NB9/NB9W to ADSL through the ADSL Quick Setup interface, details of the
connection will be summarised here.
Setting up a WAN profile goes through a set of steps which establishes connection parameters
covering the following:
Field
VPI/VCI
Con. ID
Category
Service
Interface
Protocol
IGMP
NAT
Firewall
QoS
State
Once settings are entered, click Save. Connection status can be checked under Status>Diagnostics.
Choosing a WAN Profile
In the event that you wish to set up several connection profiles on your NB9/NB9W for use in
different locations OR with different ADSL services
•
click 'Add' to add the next connection profile
•
Repeat set up steps above
You are able to cycle through connection profiles in the Status>Diagnostics window; if more than
one WAN profile exists, a button will displayed for Next Connection in the sequence.
NB9/NB9W ADSL2+ VoIP Router
YML790 Rev1
Means
Always 8/35 in Australia
Sequence number of connection (e.g. 1,2...)
ATM Service Category; leave as default
Name of connection: give this a name you will
recognise (e.g. ISP name)
Current WAN interface name
Bridge or Router Mode
Enable/Disable IGMP proxy
Enable/Disable NAT (leave enabled unless advised
otherwise by tech support)
Enable/Disable Firewall (leave enabled unless
advised otherwise by tech support)
Enable/Disable QoS; enable if VoIP services are
being used.
Enable/Disable this WAN connection
49