Establishing Your Wireless Connection (For Nb9W Only) - NetComm NB9 User Giude

Adsl2+ voip router

Hide thumbs Also See for NB9:

Table of Contents

3. Establishing your Wireless Connection (for NB9W only)

Wireless networking provides an alternative connection to using Ethernet cable. Wireless access is

enabled by default on your NB9W with the following default settings:

•

Wireless network name (SSID):

Security: WEP (64-bit) HEX key: 'a1b2c3d4e5';

•

Note:

For advanced wireless settings of your NB9W refer to the section entitled

"Digging Deeper - Advanced Settings" in this User Guide.

If you have a wireless Ethernet card on your PC, you can connect to your NB9W by following these

steps:

1. Connect the NB9W as in the diagram above, except for Point 1;

2. Enable the wireless connectivity of your PC;

3. Search for available wireless networks;

4. The default name (SSID) of the NB9W's wireless network, 'wireless', will appear;

5. Connect to the SSID 'wireless' and when prompted, enter the default HEX password

which is A1B2C3D4E5;

6. Proceed with 'Establishing an ADSL link via PPPoE' above.

NB9/NB9W ADSL2+ VoIP Router

YML790 Rev1

'wireless';

Table of Contents

Nb9w