Table of Contents
Advertisement
30/ASSEMBLING THE ENGINE
Installing gear position sensor
20.29
Installing the spacer
20.30
–
Insert the oil filter
–
Lubricate the O-ring of the oil filter cover. Install the oil filter cover
–
Mount and tighten the screws.
Guideline
Screw, oil filter cover
300011-11
–
Mount the contact springs
The contact bolts are mounted with the flat side forward; the pointed sides
face the sensor.
–
Position O-ring
300007-11
–
Install the gear position sensor
–
Position the ground wire
–
Mount and tighten the screws.
Guideline
Screw, gear sensor
302126-11
–
Grease spacer
Long-life grease (
–
Position the O-ring in the cut-out of the spacer.
302140-10
–
Grease the shaft seal ring.
Long-life grease (
–
Slide the spacer with the O-ring onto the countershaft with a twisting motion.
The cut-out with the O-ring faces inward.
The shaft seal ring rests against the spacer along its entire circumference.
302124-10
.
M5
and contact bolt
.
.
.
M5
in area
and O-ring
before mounting.
p. 210)
p. 210)
.
6 Nm (4.4 lbf ft)
.
5 Nm
Loctite
®
243™
(3.7 lbf ft)
150
Advertisement
Table of Contents
