02/Handlebar, Instruments; Handlebar Position; Adjusting Handlebar Position; Checking The Play In The Throttle Cable - KTM 690 Enduro EU 2008 Repair Manual

Hide thumbs Also See for 690 Enduro EU 2008:
Table of Contents

Advertisement

02/HANDLEBAR, INSTRUMENTS

Handlebar position

6.1
A
0 0 A
B
0 0 B

Adjusting handlebar position

6.2
1
0 0 1
2
0 0 2

Checking the play in the throttle cable

6.3
On the upper triple clamp, there are 2 holes at a distance
Distance
between holes
The holes on the handlebar support are placed at a distance
Distance
between holes
The handlebar can be mounted in 4 different positions. In this way, the handlebar can
be installed in the position most comfortable for the rider.
400271-11
Remove the four screws
and lay it to one side.
Info
Protect the motorcycle and its attachments from damage by covering them.
Do not bend the cables and lines.
Remove the two screws
Place the handlebar support in the required position. Fit and tighten the two
screws
.
400271-10
Guideline
Screw, handlebar support
Info
Position the left and right handlebar supports evenly.
Position the handlebar.
Info
Make sure cables and wiring are positioned correctly.
Position the handlebar clamp. Fit and evenly tighten the four screws
Guideline
Screw, handlebar clamp
Move the handlebar to the straight-ahead position. Move the throttle grip back-
wards and forwards to ascertain the play in the throttle cable.
Throttle cable play
»
If the throttle cable play does not meet specifications:
Adjust the play in the throttle cable. (
Danger
Danger of poisoning Exhaust gases are poisonous and inhaling them may
result in unconsciousness and/or death.
400192-10
When running the engine, always make sure there is sufficient ventila-
tion, and do not start or run the engine in an enclosed space without an
effective exhaust extraction system.
Start the engine and let it run idle. Move the handlebar to and fro over the entire
steering range.
The idle speed must not change.
»
If the idle speed changes:
15 mm (0.59 in)
3.5 mm (0.138 in)
. Remove the handlebar clamp. Remove the handlebar
. Remove the handlebar support.
M10
M8
20 Nm
(14.8 lbf ft)
3... 5 mm (0.12... 0.2 in)
p. 31)
30
to each other.
from the center.
40 Nm
(29.5 lbf ft)
.
Loctite
®
243™

Advertisement

Table of Contents
loading

Table of Contents