11/WIRING HARNESS, BATTERY
Adjusting the engine characteristic
14.9
Warning
Fire hazard The electrical system can be overloaded by the use of incorrect
fuses.
–
Use only fuses with the prescribed amperage. Never by-pass or repair
fuses.
–
Replace with a spare fuse of the right rating.
Fuse (75011088010) (
Fuse (75011088015) (
Tip
Put a new spare fuse in the fuse box for future use if needed.
–
Checking the function of power consumers.
–
Close the fuse box cover.
–
Mount the seat. (
–
Switch off the ignition by turning the ignition key in the position
(690 Enduro EU, 690 Enduro AUS/UK)
–
Remove the seat. (
–
Pull the Map‑Select switch and holder
–
Pull the Map‑Select switch out of the holder.
100237-10
–
Turn the adjusting wheel until the desired digit is next to marking
Set the Map‑Select switch to Soft.
–
Set the adjusting wheel to position 1.
Soft – reduced homologated peak performance for better driveability.
Set the Map‑Select switch to Advanced.
–
Set the adjusting wheel to position 2.
Advanced – homologated performance with extremely direct responsive-
ness.
Set the Map‑Select switch to Standard.
100238-10
–
Set the adjusting wheel to position 3, 4, 5, 6, 7, 8 or 9.
Standard – homologated performance with balanced responsiveness.
Set the Map‑Select switch to poor fuel quality.
–
Set the adjusting wheel to position 0.
Poor fuel quality – homologated performance is reduced in accordance with
the fuel quality, use for no more than 1 tank of fuel
–
Position the Map‑Select switch in the holder.
–
Slide the Map‑Select switch with the holder downward onto the retaining bracket.
–
Mount the seat. (
p. 178)
p. 178)
p. 58)
(690 Enduro USA).
p. 58)
upward off of the retaining bracket.
p. 58)
76
.