Table of Contents
Advertisement
04/SHOCK ABSORBER, SWINGARM
Checking the riding sag of the shock absorber
8.6
Adjusting the spring preload of the shock absorber
8.7
Danger
Danger of accidents Disassembly of pressurized parts can lead to injury.
–
The shock absorber is filled with high density nitrogen. Adhere to the description provided.
Info
Before changing the spring preload, make a note of the present setting, e.g., by measuring the length of the spring.
–
Measure distance
–
With another person holding the motorcycle, the rider, wearing full protective cloth-
ing, sits on the seat in a normal sitting position (feet on footrests) and bounces up
A
0 0 A
and down a few times.
The rear wheel suspension levels out.
–
Another person now measures the distance between the rear axle and a fixed point.
–
Note down the value as dimension
Info
The riding sag is the difference between measurements
–
Check the riding sag.
Riding sag
0 0 C
C
»
If the riding sag differs from the specified measurement:
–
Adjust the riding sag. (
400990-10
–
Remove the shock absorber. (
–
After removing the shock absorber, clean it thoroughly.
–
Loosen locking ring
–
Turn adjusting ring
Hook wrench (T106S) (
–
Measure the overall spring length without a load.
–
Tension the spring by turning the adjusting ring
Guideline
Spring preload
700541-01
Info
Depending on the static sag and/or the riding sag, it may be necessary to
increase or decrease the spring preload.
–
Tighten locking ring
–
Install the shock absorber. (
of rear wheel unloaded. (
.
80... 90 mm (3.15... 3.54 in)
p. 36)
p. 36)
.
until the spring is no longer under tension.
p. 220)
19 mm (0.75 in)
.
p. 37)
p. 34)
and
.
to the prescribed value.
35
Advertisement
Table of Contents
