Table of Contents
Advertisement
01/FORK, TRIPLE CLAMP
Removing fork legs
5.7
–
Raise the motorcycle with the lift stand. (
–
Tie the rear of the vehicle down.
–
Remove screws
–
Press back the brake linings with a light lateral tilting of the brake caliper on the
brake disc. Carefully pull the brake caliper backwards from the brake disc.
Info
Do not pull the handbrake lever when the brake caliper is removed.
201332-10
–
Loosen screws
–
Unscrew screw
wheel spindle out of the axle clamp. Remove screw
Warning
Danger of accidents Reduced braking efficiency caused by damaged brake
discs.
–
Always lay the wheel down in such a way that the brake disc is not dam-
aged.
201333-10
–
Holding the front wheel, withdraw the wheel spindle. Take the front wheel out of
the fork.
–
Remove screws
201334-10
–
Remove the screws of the wheel speed sensor
one side.
201335-10
–
Loosen screws
bottom.
201336-10
.
and screw
.
about 6 turns and press your hand on the screw to push the
. Take the brake line and wiring harness out of the clamp.
of the triple clamp on both sides. Remove the fork legs from the
p. 9)
.
. Hang the wheel speed sensor to
14
Advertisement
Table of Contents
