Table of Contents
Advertisement
38/LUBRICATION SYSTEM
Checking the engine oil pressure
23.3
Warning
Danger of scalding Engine oil and gear oil get very hot when the motorcycle is ridden.
–
Wear appropriate protective clothing and safety gloves. In case of burns, rinse immediately with lukewarm water.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
–
Check the engine oil level.
Info
After switching off the engine, wait one minute before checking the level.
The engine oil must be between the lower and upper edge of the oil level viewer.
»
If the engine oil level is not at the specified level:
–
Add the engine oil. (
100210-10
–
Remove screw
302039-10
–
Position the banjo bolt with the connector and sealing rings. Mount and tighten the
banjo bolt.
Guideline
Banjo bolt
Oil pressure adapter (77329006000) (
–
Connect the pressure tester to the special tool without the T-plate.
Pressure testing tool (61029094000) (
302040-10
–
Check the engine oil level. (
Danger
Danger of poisoning Exhaust gases are poisonous and inhaling them may
result in unconsciousness and/or death.
–
When running the engine, always make sure there is sufficient ventila-
tion, and do not start or run the engine in an enclosed space without an
effective exhaust extraction system.
–
Start the engine and let it run warm.
–
Check the engine oil pressure.
Engine oil pressure
Coolant temperature: ≥ 70 °C
(≥ 158 °F)
Engine speed: 1,500 rpm
Coolant temperature: ≥ 70 °C
(≥ 158 °F)
Engine speed: 5,000 rpm
»
If the specification is not reached:
p. 162)
.
M10x1
p. 219)
p. 157)
≥ 0.4 bar (≥ 6 psi)
≥ 1.5 bar (≥ 22 psi)
8 Nm (5.9 lbf ft)
p. 214)
158
Advertisement
Table of Contents
