Table of Contents
Advertisement
41/THROTTLE VALVE BODY
Flashing the EFI control unit and/or the EPT control unit
25.3
–
Fix screws
–
Press "Continue".
–
Read the information page on the KTM diagnostics tool and, using "Continue", start
the "ECU Reset" menu.
The control unit is reset.
–
Complete the procedure with "Continue".
–
Switch off the ignition by turning the ignition key in the position
(690 Enduro EU, 690 Enduro AUS/UK)
–
Plug in the connector of the motor drive DR
–
Switch to the main menu.
–
Switch on the ignition by turning the ignition key in the position
(690 Enduro EU, 690 Enduro AUS/UK)
–
Select model.
–
Select "ECU Diagnostics".
–
Highlight "EPT throttle motor drive control LC4" control unit.
601136-10
–
Press "Continue".
–
"Read trouble code" selected.
–
Complete the procedure with "Back".
–
Select "Delete trouble codes".
–
Complete the procedure with "Back".
Danger
Danger of poisoning Exhaust gases are poisonous and inhaling them may
result in unconsciousness and/or death.
–
When running the engine, always make sure there is sufficient ventila-
tion, and do not start or run the engine in an enclosed space without an
effective exhaust extraction system.
–
Start the engine and perform an initialization run.
Guideline
Initialization run
Condition
The ignition is on.
The diagnostics tool is connected and running.
EFI control unit
–
Select model.
–
Select "ECU Diagnostics".
–
Highlight the "Injection management EFI LC4" control unit.
–
Press "Continue".
–
Select "ECU Flashing".
–
"Please enter the password:"
–
Press "Continue".
400687-60
–
Read the safety instructions and create the necessary preliminary conditions.
–
Confirm the instructions by clicking on "OK".
–
Press "Select file" and select a new mapping.
Info
"The BLZ file and the exhaust system must match!"
–
Press the "ECU flash process" button.
–
Read the prompt and confirm with "OK".
The new mapping is loaded.
–
Switch to the main menu.
with locking varnish.
(690 Enduro USA).
.
(690 Enduro USA).
15 min
169
Advertisement
Table of Contents
