Detail Environment Settings; Figure 5.2 [Environment Settings] Window In Case Of Internet Connection (Only Mail); Table 5.2 Items In The [Environment Settings] Window In Case Of Internet Connection (Only Mail) - Fujitsu Primequest 2000 Series Installation Manual

CHAPTER 5 CHAPTER 5 REMCS Service Detail Settings

5.2 Detail Environment Settings

5.2 Detail Environment Settings
This item is used to change the communication environment settings for Internet use.
The displayed window contents depend on the authentication type of the connection configuration as shown
in

FIGURE 5.2 [Environment settings] window in case of internet connection (only mail)

[Environment settings] window in case of P-P
Take adequate care when making the setting. Otherwise it may become impossible to send events to the
REMCS Center if an incorrect setting is made.
FIGURE 5.2 [Environment settings] window in case of internet connection (only mail)

TABLE 5.2 Items in the [Environment settings] window in case of internet connection (only mail)

Input item
E-Mail settings
Timeout
Retry Count
Retry interval
SMTP server
PORT No.
Type of encrypted
connection
Authentication settings
Authentication type
AUTH SMTP type
(This entry is valid at
setting [Authentication
type] in [AUTH
SMTP])
connection.
Maximum Input
number of
digits
4 Required
2 Required
3 Required
128 Required
5 Required
- Required
- Required
- Required
Enter the timeout trigger for E-Mail (seconds)
in single-byte numeric characters.
Range: 60 to 3600
Enter the retry count for E-Mail in single-byte
numeric characters.
Enter the retry interval for E-Mail in single-
byte numeric characters.
Range: 1 to 600
Enter the name of SMTP server or IP
address in single-byte numeric character and
alphabets
Enter the port number of the SMTP server in
single-byte numeric characters.
Initial value: 25 (Well Known Port is used.)
Range: 1 to 65535
Select type of encrypted connection of SMTP
over SSL from 'None' (default), 'STARTTLS'
and 'SSL/TLS'
Select authentication type from 'None',
'AUTO' (default), 'POP before SMTP', 'AUTH
SMTP'.
Select SMTP authentication from 'Auto'
(default), 'CRAM-MD5', 'PLAIN', 'LOGIN'.
45
and FIGURE 5.3
Description
CA92344-0542-02