Fujitsu Primequest 2000 Series Installation Manual page 64

CHAPTER 5 CHAPTER 5 REMCS Service Detail Settings
5.2 Detail Environment Settings
User ID
Password
POP settings (When you specify [POP Before SMTP] for [Authentication type])
POP server
Port No.
wait time after POP
authentication
Connection control
IP version priority
Others
Sender E-mail
Address
Large data
transmission method
Split size
*1: It is required if you select item except for 'None' in authentication type.
*2: It is required if you select item except for 'POP Before SMTP' in authentication type.
*3: It is required if you select item except for 'None' in dividing method.
64 Required (*1)
64 Required (*1)
128 Required (*2)
5 Required
4 Required
- Required
128 Required
- Required
3 Required (*3)
Enter user ID of authentication server in
single-byte numeric number and alphabets.
Enter password of authentication server in
single-byte numeric number and alphabets.
Entered values are all displayed as *.
Enter the name of POP server or IP address
in single-byte numeric number and
alphabets.
Enter the port number of the POP3
authentication server in single-byte numeric
characters.
Initial value: 110 (Well Known Port is used.)
Range: 1 to 65535
Enter the wait time from POP3 authentication
to the start of mail sending (milliseconds) in
single-byte numeric characters.
Recommended value: 1000 ms
Range: 0 to 30000
Select the priority of IP version from 'none',
'IPv4 (default)' and 'IPv6'
Enter the e-mail address of originator in
single-byte numeric characters and
alphabets.
Select dividing method from 'none', 'event
dividing' (default).
Enter dividing size in single-byte numeric
characters.
- mail
Default: 64 KB
Range: 10 to 100 KB
- event
Default: 512 KB
Range: 64 to 512 KB
46
CA92344-0542-02