BMW 1989-1995 525i Service Manual page 354

512-2
DOOR W INDOWS
0006592
Fig . 3. Outer window channel seal being removed using wooden
wedge.
Rear door window, removing/installing
1. Remove interior trim pane l. See 41 1 Doors .
2. Lower window. Remove retaining clips from window
slides . See Fig. 1. given earlier.
NOTE -
Once window is lowered. disconnect harness connec-
tor from power window motor to pre vent accidental op -
eration of the window.
3. Pry window lif1ing arms out of left and right slides. See
Fig. 2. given earlier.
4. Remove inner and outer window seals from top of door.
See Fig. 3. given earlier. Lift off remain ing inner window
seal.
7. Remove outside trim cover from upper part of door
frame. See Fig. 4.
5. Remove plastic window trim from inside door frame.
See Fig. 5.
7. Pull off exterior trim cover from rear window guide. Pull
rubber window channel from door frame.
6. Remove screws from interior of rear window guide.
See Fig. 6.
- ~
--..".. . 1 . - · 1
. . .
I -
00 11699
Fig . 5. Remove InSide widow trim pieces
IA
and B)
by
prying/pulling
off of door trame.
00 11698
Fig . 4. Remove screws from window tnm cover (arro w s) and re-
move cover.
8. Remove outside trim cover mounting screws and re-
move trim cover by sliding up and off window guide.
See Fig. 7.
8. Remove window glass from above.
9. Remove window glass from above.
Installation is the reverse of removal. When inserting win-
dow into door . be sure glass aligns with left and right guides as
it is lowered into the door . If necessary. adjust door window as
described later.
Installation is the reverse of remova l. When inserting win-
dow into doo r. be sure glass aligns with left and right guides as
it is lowered into the door . If necess ary. adjust door window as
described below.
WINDOWSERVICE