BMW 1989-1995 525i Service Manual page 249

AUTOMATIC TRANSMISSION
240-13
3. Disconnect oil filler pipe from oil sump . See Rg . 21 .
Fig. 21 .
all
filler pipe (arro w) on 4HP 22 transmission.
4. Remove oil sump mounting bolts and remove sump.
See Fig. 22.
502 4
Fig. 22. ATF sum p mounting bolts and clamping brackets (arro w s).
5. Remove strainer mounting screws and remove strain-
er. See Fig. 23.
@.l,@
1 \'
1"-./
If
@
@
"
II
84 19 .A
Fig . 23 . ATF fluid strainer and mounting bolls on 4HP 22 transmission.
NOTE -
Make sure the O -ring is attached to top of strainer when
remo ving.
Installation is the reverse of removal. Always replace the
drain plug seal and all gasket(s). Clean the sump and the
sump magnets using a lint-free cloth. When mounting the
sump. mount the curved sump clamping brackets at the front
and rear corners of the sump. Mount the straight clamping
brackets at the sump sides. The short legs on the clamps
should contact the oil sump. Fill the transmission with the
specified amount of fluid.
NOTE -
Check the A TF level with the car on level surface. en-
gine running. and sefector lever in park. The A TF level
should be between the dipstick min. and max. marks
when the A TF is at
a
temperature 01 approx. 80' C
( t 75' F).
ATF specification
• Oil change volume
Dexron II 3.0 L (3.2 qt.)
Tightening Torques
• ATF drain plug to ATF sump 16 Nm (1 2 fH b)
• ATF strainer to valve body 8 Nm (71 in-lb)
• ATF sump to transmission . _ 6 Nm (53 in-lb)
TRANSMISSION SERVICE