Filling The Brake Fluid Reservoir; Purging Brake Line; To Fill The Reservoir - E-TON CXL-150 Owner's Manual

After riding your unit, be sure to clean any build up
of mud, sand and dirt from the brake rotor skid
plate. This will protect the rotor disc from rust and
corrosion.

To Fill the Reservoir

Remove the reservoir cover by removing the two
cover bolts.
Fill the reservoir to 1/8"
from top with Dot-3
SAE-J1703 grade
brake fluid.
Caution: DO NOT
allow dirt to fall into
the reservoir.
Refold the cover gasket
as shown in picture and
replace cover and bolts
Copyright ©2008-2009 ETON America, all rights reserved.
Purging Brake
For the hydraulic brake system to operate safely,
the brake system must be purged of air in the lines
and reservoir.
To bleed the air will require two people to perform
the following procedure.
1. Place a drain pan under the brake caliper
to catch the fluid.
2. Open the bleeder valve ½ turn counter
clockwise.
3. Squeeze the brake lever to expel air from
the system.
4. While holding the brake lever, close the
bleeder valve.
5. Repeat steps 2 through 4 until the brake
fluid coming from the bleeder valve is a
solid stream without any air, then close the
valve and replace rubber protection cap.
6. Test the brake system by squeezing the
lever, the lever should feel firm and stop
without fading.
Page 17
Lines