Furuno NAVpilot-711C Installation Manual page 3

SAFETY INSTRUCTIONS
Please read these safety instructions before you install the equipment.
WARNING
CAUTION
Warning, Caution
WARNING WARNING
Turn off the power at the switchboard
before beginning the installation.
Fire or electrical shock can result if the
power is left on.
Use the proper power cable.
Use JIS type DPY-2.5 or the equivalent.
Other types can cause fire.
Confirm that no one is near the rudder
when bleeding air from oil cylinder.
The rudder may move unexpectedly,
possibly causing bodily injury.
When connecting a geomagnetism
detection type heading sensor,
correct magnetic field deviation.
If an autopilot is used without the compen-
sation, unexpected course change may
occur.
Set REMOTE CONTROLLER 1/2 on
SYSTEM SETUP menu properly accord-
ing to remote controller connected.
If not done properly, malfunction may
occur. Especially, take care when
setting the NFU-type remote controller.
Indicates a condition that can cause death or serious injury if
not avoided.
Indicates a condition that can cause minor or moderate injury if
not avoided.
Prohibitive Action
Control
Unit
Processor Unit
FAP-7002
Remote
controllers
Mandatory Action
CAUTION CAUTION
Confirm that the power supply voltage
is compatible with the voltage rating
of the equipment.
Connection to the wrong power supply
can cause fire or damage the equipment.
Observe the following compass safe
distances to prevent interference to a
magnetic compass:
Standard
compass
FAP-7001 0.35 m
FAP-7011 0.35 m
FAP-7011C 0.50 m
FAP-7021 0.35 m
0.45 m
0.30 m
Separate the reversible pump at least one
meter from communications equipment,
communications antenna and communi-
cations cabling to prevent interference.
Steering
compass
0.30 m
0.30 m
0.35 m
0.30 m
0.30 m
0.30 m
i