Nmea0183 Port Setup - Furuno NAVpilot-711C Installation Manual

3. INITIAL SETTINGS
6. Rotate the knob to select [SELECT OUTPUT PGN LIST], and the display looks some-
thing like the one shown below.
This display shows all the NMEA 2000 sentences that can be output to the NAVpilot.
The sentences selected for output show "ON". To turn a sentence ON or OFF, go to
step 7. (Corresponding equipment must be connected to turn a sentence ON.) If you
do not need to change the settings, go to step 8.
Note: Turn OFF the sentence "127245 (rudder)" in case of Fantum Feedback
7. To turn an NMEA 2000 sentence on or off, do the following:
1) Rotate the knob to select a sentence then push the knob.
2) Rotate the knob to select [ON] or [OFF] then push the knob.
8. Press the MENU key to return to the [CAN BUS SETUP] menu.
9. Rotate the knob to select [REFRESH] then push the knob.
10.Wait five seconds to allow the system to refresh the device list.
3.7

NMEA0183 Port Setup

NMEA0183 SETUP
PORT1
PORT2*
1. The cursor is selecting [PORT1]; push the knob.
2. The cursor is selecting [NAMING: PORT1]. This menu item lets you change the name
of the port. For example, equipment type, model number, etc. The name can have a
maximum of 14 alphanumeric characters. If you don't need to change the name, go to
step 3.
3-20
Example for NAVpilot-700
CAN BUS
126992: OFF 127237: ON
127245: OFF 127250: OFF
127251: OFF 127258: OFF
128259: OFF 128267: OFF
129025: OFF 129026: OFF
129029: OFF 129033: OFF
129283: OFF 129284: OFF
129285: OFF 130306: OFF
130310: OFF 130311: OFF
130312: OFF
SYSTEM TIME*
*: The PGN title of the selected PGN is displayed.
OFF
ON
*: Not shown when [BOAT TYPE] is set
to [VOLVO EVC BOAT]
NMEA0183 PORT1
NAMING: PORT1
OUTPUT FMT: NMEA0183 V3.0
BAUDRATE: 4800BPS
SELECT OUTPUT SENTENCE
INCOMING NMEA0183 DATA
TM
.