Wiring; General Wiring - Furuno NAVpilot-711C Installation Manual

2. WIRING

2.1

General Wiring

All units are connected to the Processor Unit. Separate the cables as far as possible from
the cables that transmit radio frequency or pulsed signals. At least one meter separation
is recommended.
PROCESSOR UNIT
FAP-7002
Power supply
12-24 VDC
Ship Steering System*
Solenoid valve
Reversible pump
Hydraulic
linear drive
NMEA0183 PORT1 (Nav equip.)
NMEA0183 PORT2
(IF-700IPS or Nav equip.)
CANbus (FI-50, PG-700, etc.)
1
*
: Attach the terminator to the empty
connector of the last control unit in the series.
2
*
: Not required for Fantum Feedback
3
*
: Not required for the IPS drive.
3
Remote
PC
Controller
or
Distributor
Remote
Controller
Distributor
TM
.
Terminator BD-07AFFM-LR7001*
(supplied)
BD-07AF-07AF-LR-100
BD-07AF-07AF-LR-100
BD-07AFFM-LR-150
CONTROL UNIT
FAP-7001/7011/7011C
RUDDER
REFERENCE
UNIT
2, 3
FAP-6112* *
or
Contact signal out
Contact signal in
1
or
CONTROL
UNIT
FAP-7021
or
Terminator
1
BD-07AFFM-LR7001*
(supplied)
2-1