Furuno NAVpilot-711C Installation Manual page 48

3. INITIAL SETTINGS
3. The cursor is selecting [NO]; push the knob. Rotate the knob to select [YES] then
push the knob to show the following message.
4. Press the (or
5. Remove the appropriate rubber cap of the cylinder to bleed air.
6. Press the (or
7. Remove the appropriate rubber cap of the cylinder to bleed air.
8. Repeat steps 4-7 to bleed air completely.
Rudder test
Note: The rudder test can not be performed if the drive unit has not been selected.
1. Go back to the [DOCKSIDE SETUP] menu.
2. Rotate the knob to select [RUDDER TEST] then push the knob.
3. The cursor is selecting [NO]; push the knob. Rotate the knob to select [YES] then
push the knob to show the following messege.
4. Center the rudder then push the knob.
5. Confirm the direction that the rudder move with pressing the
6. Release the key.
7. Press the (or
8. Turn the helm or press the
knob.
9. Long press the
10.When the rudder is reached to hard limit, release the
messsage.
Long-press the
then select [YES]. If not, select [NO] and go back to step 8.
11.At the completion of the rudder test, one of the results shown below appears.
• RUDDER TEST COMPLETED.
3-12
AIR BLEEDING
PUSH ARROW KEYS TO ENABLE
PUMPSET
PUSH MENU KEY WHEN DONE
) key.
) key.
USE WHEEL TO
CENTER RUDDER BEFORE
RUDDER TEST.
ARE YOU SURE?
YES ENTER NO MENU
) key according to the direction that confirmed at step 5.
(or ) key hard-over to PORT/STBD then push the
(or ) key hard-over to the opposite direction from step 8.
HAS THE RUDDER REACHED
THE HARD LIMIT?
YES ENTER
(or ) key to turn hard-over in direction opposite that done in step 8
key.
(or ) key to display following
NO MENU