Furuno NAVpilot-711C Installation Manual page 44

3. INITIAL SETTINGS
10.Press the (or
11.Remove the appropriate rubber cap of the cylinder to bleed air.
12.Press the (or
13.Remove the appropriate rubber cap of the cylinder to bleed air.
14.Repeat steps 10-13 to bleed air completely.
Rudder limit setup
15.Go back to the [DOCKSIDE SETUP] menu. Select [RUDDER LIMIT SPEED] and
push the knob.
Set the rudder center position, then set the maximum rudder limits or "hard-over" points
for the rudder system.
NAVpilot will AUTOMATICALLY set the port/starboard direction of the rudder angle in this
step. It does not matter which way the rudder reference unit arm or linear sensor rod is
installed as this correction will be done electronically.
NAVpilot will AUTOMATICALLY "linearize" the rudder indication values if the rudder turns
further in one direction than the other direction. Therefore, it is recommended that you
make both port and starboard rudder values the same. This will avoid confusion for the
customer during operation. Also, numeric value selected is not critical and need not be
measured as long as you feel that your estimation is close to the proper value.
16.The cursor is selecting [RUDDER CENTER SETUP]; push the knob.
17.Turn the helm so rudder is centered then push the knob. The [RUDDER LIMIT
SETUP] menu appears.
18.Rotate the knob to select [PORT LIMIT SETUP].
19.Turn the helm hard-over to port then enter port rudder limit.
20.Rotate the knob to select [STBD LIMIT SETUP].
21.Turn helm hard-over to starboard then enter starboard rudder limit.
Note 1: If the angle is wrong at step 16, 19 or 21 an error message appears. In this case
go back to the [RRU SENSOR ALIGNMENT] menu and check if the RRU setting is cor-
rect.
3-8
) key until the indicator is completely filled (in black).
) key until the indicator is completely filled (in black).
RUDDER LIMIT SETUP
RUDDER CENTER SETUP
PORT LIMIT SETUP
STBD LIMIT SETUP
CENTER RUDDER THEN PRESS
ENTER KNOB.
APPROX. CENTER RUDDER
AND PUSH ENTER TO SET
ARE YOU SURE?
YES ENTER
??°
??°
NO MENU