Furuno NAVpilot-711C Installation Manual page 57

1) Push the knob.
2) Rotate the knob to select character then push the knob.
3) The cursor moves to the next character. Repeat step 2 to change the character.
You can select the input location with the
3. Rotate the knob to select [OUTPUT FMT] then push the knob.
4. Rotate the knob to select the output format of the equipment then
push the knob.
5. Rotate the knob to select [BAUDRATE] then push the knob.
6. Rotate the knob to select the baud rate of the equipment then push the
knob.
7. Rotate the knob to select the [SELECT OUTPUT SENTENCE] then push the knob.
One of the following displays appears depending on the NMEA output format
selected.
DBT: OFF
HDM: OFF
RMB: OFF
VHW: OFF
VWT: OFF
8. To turn a sentence ON or OFF, rotate the knob to select the sentence, push the knob,
rotate the knob to select [ON] or [OFF] then push the knob.
9. Press the MENU key to return to the [NMEA0183 PORT1] menu.
10.Rotate the knob to select [INCOMING NMEA0183 DATA] then push the knob.
This display shows the NMEA0183 sentences currently being received.
11.Press the MENU key twice to return to the [NMEA0183 PORT SETUP] menu.
If you have equipment connected to NMEA0183 PORT2, set up the equipment similar
to how you set up the equipment in NMEA0183 PORT1.
Note: [PORT2] is not shown when [BOAT TYPE] is set to [VOLVO EVC BOAT].
VER 1.5
GGA: OFF GLL: OFF
HDT: OFF MTW: OFF
RMC: OFF ROT: OFF
VTG: OFF VWR: OFF
ZDA: OFF
VER 3.0
DBT: OFF DPT: OFF
GLL: OFF GNS: OFF
HDT: OFF MTW: OFF
RMB: OFF RMC: OFF
*
RSA: OFF VHW: OFF
ZDA: OFF
*: Turn OFF the sentence "RSA" in case of Fantum Feedback
INCOMING NMEA0183 DATA
AAM DBT HDG
APB DPT HDM
BOD GGA HDT
BWC GLL MTW
BWR GNS MWV
and keys.
VER 2.0
DBT: OFF DPT: OFF
GLL: OFF HDG: OFF
MTW: OFF MWV: OFF
RMC: OFF ROT: OFF
VHW: OFF VTG: OFF
GGA: OFF
HDG: OFF
MWV: OFF
ROT: OFF
VTG: OFF
RMB VHW ZDA
RMC VTG
ROT VWR
THS VWT
TLL XTE
3. INITIAL SETTINGS
NMEA0183 V1.5
NMEA0183 V2.0
NMEA0183 V3.0
4800BPS
38400BPS
GGA: OFF
HDT: OFF
RMB: OFF
*
RSA: OFF
VDA: OFF
TM
.
3-21