Furuno NAVpilot-711C Installation Manual page 60

3. INITIAL SETTINGS
3. If you selected [FUNCTION KEY], do the following to select a function. If not go to
step 4.
1) Rotate the knob to select [FUNC KEY] then push the knob.
Note: For Fantum Feedback
[FUNC KEY], only the [TURN 180°] is selective.
2) Rotate the knob to select an option then push the knob.
180° TURN
3) Rotate the knob to select [PORT/STBD] then push the knob.
4) Rotate the knob to select the direction of the turn then push the knob.
4. If you have another device connected to the UNIVERSAL IN port, set it up at [IN
PORT2].
5. Rotate the knob to select [OUT PORT1] then push the knob.
EXT BUZZER*
STBY MODE
AUTO MODE
NAV MODE
AUTO/NAV MODE
AP CONTROL
PORT ARROW KEY
STBD ARROW KEY
DISABLE
6. Rotate the knob to select the action that triggers an external buzzer or lamp then push
the knob.
7. If you have another device connected to the UNIVERSAL OUT port, set it up at [OUT
PORT2].
3-24
TURN OF
CIRCLE
ORBIT
SPIRAL
SQUARE
FIG 8
ZIGZAG
TM
, when the [INPORT 1] or [INPORT 2] is selected to
SQUARE FIGURE EIGHT
PORT
STBD
A lamp lights or an external buzzer sounds when;
the NAVpilot goes into the STBY mode.
the NAVpilot goes into the AUTO mode.
the NAVpilot goes into the NAV mode.
the NAVpilot switches between the AUTO and NAV modes and vice versa.
the rudder is moved.
the PORT arrow key (
the STBD arrow key (
Function disabled.
* The [BUZZER] setting on the [ALARM] menu is
automatically selected to [INTERNAL+EXTERNAL].
Applicable to both OUT PORT1 and OUT PORT2.
180°
SPIRAL
ORBIT
ZIGZAG
on the NAVpilot is operated
)
on the NAVpilot is operated.
)