Dockside Setup For Fantum Feedback Tm - Furuno NAVpilot-711C Installation Manual

When the following messages appear, rudder test is completed successfully.
• RUDDER TEST COMPLETED.
• RUDDER SPEED IS TOO FAST TO CONTROL THE VESSEL. THE VESSEL MAY
NOT BE CONTROLLED PROPERLY.
• RUDDER SPEED IS TOO SLOW TO CONTROL THE VESSEL. THE VESSEL
MAY NOT BE CONTROLLED PROPERLY.
Note 1: If rudder deadband is higher than 1.3°, the boat cannot be controlled correctly.
Check for air in the steering system and if the rudder speed is greater than 10°/s.
Note 2: If you set the deadband manually, do not set the value too low. Hunting can result.
Note 3: if the rudder test could not be completed successfully one of the following mes-
sages appear. Do the test again after resolving the problem.
• RUDDER TEST FAILED.
• DEADBAND IS TOO BIG TO CONTROL THE VESSEL. THE VESSEL MAY NOT BE
CONTROLLED PROPERLY. PLEASE SEE INST MANUAL FOR MANUAL DB SET-
TING.
• RUDDER ANGLE ERROR CHECK DRIVE CIRCUIT
• RUDDER DRIVE ERROR
3.5.2 Dockside setup for Fantum Feedback
DOCKSIDE SETUP
DRIVE UNIT SELECTION:
AIR BLEEDING: NO
RUDDER TEST: NO
HELM SENSOR TEST*
SAFE HELM/P.ASSIST SETUP*
How to set the drive unit
1. Use the knob to select [DRIVE UNIT SELECTION] then push the knob.
2. Rotate the knob to select [REVERSIVLE 24V], [REVERSIBLE 12V], [SAFE HELM
24V], or [SAFE HELM 12V] then push the knob.
Air bleeding
Note: Air bleeding can not be performed if the drive unit has not been selected.
1. Go back to the [DOCKSIDE SETUP] menu.
2. Rotate the knob to select [AIR BLEEDING] then push the knob.
UNKNOWN
* Displayed if Accu-Steer drive
unit is selected.
AIR BLEEDING
AIR BLEEDING: NO
3. INITIAL SETTINGS
TM
3-11