Furuno NAVpilot-300 Installation Overview
Furuno NAVpilot-300 Installation Overview

Furuno NAVpilot-300 Installation Overview

Volvo penta ips
Hide thumbs Also See for NAVpilot-300:

Advertisement

Volvo Penta IPS Installation
This document describes the basic information on Volvo Penta IPS, Volvo IPS Gateway
with Navpilot 300 installation. Please refer to the Navpilot 300 Installation and
Operator's manual for full instructions.
INDEX
1. Volvo Penta IPS
1-1. What is Volvo Penta IPS?
1-2. IPS Network and Navpilot 300
2. VOLVO IPS Gateway # 000-022-971-00
NAVpilot-300
Model:
Overview
3. Basic Installation and Operation
3-1. Wiring
3-2. Initial Settings on NAVpilot-300
3-3. Operation
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the NAVpilot-300 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Furuno NAVpilot-300

  • Page 1 Operator’s manual for full instructions. INDEX 1. Volvo Penta IPS 3. Basic Installation and Operation 1-1. What is Volvo Penta IPS? 3-1. Wiring 1-2. IPS Network and Navpilot 300 3-2. Initial Settings on NAVpilot-300 2. VOLVO IPS Gateway # 000-022-971-00 3-3. Operation...
  • Page 2 The IPS consists of a NMEA2000 based network called EVC (Electric Vessel Control). This interface allows the Navpilot-300 to control the steering system electrically. The NAVpilot-300 is interfaced to the EVC via the Volvo IPS Interface Unit and a Y-cable, part # 000-022-971-00.
  • Page 3 D, or E type. These VP IPS drive versions have been installed on all IPS systems for the past several years. All new VP IPS vessels are compatible with the NAVpilot-300 via the IPS gateway. It is easy to confirm whether the IPS drive is a C, D, or E version. If you visually confirm that the boat has the same Throttle and Joystick controllers as pictured below, it is compatible with the NAVpilot-300.
  • Page 4 2. Locate the “MULTI LINK” bus cable or find an Open Port on an EVC Bus connector to make the VP IPS Gateway Connection. The bus cable connections and hub (if installed) will be located close to the EVC unit. 3.
  • Page 5 “EVCS Drive" will allow NAVpilot-300 system to communicate with the Volvo IPS gateway. Next in [EVCS Power supply]- select [Output]. This will supply power to the Navpilot 300 DBW CAN bus and the Volvo IPS gateway. With EVCS Pwr Supply set to Output you should see a red LED on the IPS gateway.
  • Page 6 VOLVO EVC unit automatically sets the Navpilot-300 to STBY, just like the Safe Helm mode. When this happens, the NAVpilot-300 will display the “OVRD” icon on the top of the screen.

Table of Contents