Furuno NAVpilot-711C Installation Manual page 70

3. INITIAL SETTINGS
How to select the source for nav data
1. At the [NAV OPTION] menu, rotate the knob to select [NAV DATA SOURCE] then
push the knob.
2. Rotate the knob to select [DATA SOURCE] and push the knob.
3. Rotate the knob to select source then push the knob. If you have more than one
source of nav data, you can select [BOTH]. In this case, the nav data fed by
[SOURCE2] is used when that of [SOURCE1] is not available.
4. Rotate the knob to select [SOURCE1] then push the knob.
- - - - - - - - - - - - - -
NAVNET3: 000C2F
PORT2*
If you have some equipment which outputs nav data, the name appears in the win-
dow. In the example above, a NavNet 3 equipment, with unique number of 000C2F, is
connected.
5. Rotate the knob to select source then push the knob. If you have more than one
device that outputs nav data, you can select it at [SOURCE2].
Note: If you have NavNet vx2 equipment connected and it is synchronized with the
NAVpilot ([NAVNET2] turned on in the [NAV OPTION] menu), [SOURCE2] is automati-
cally selected.
3-34
NAV DATA SOURCE
DATA SOURCE: SOURCE1
SOURCE1: - - - - - - - - - - - - - -
SOURCE2: - - - - - - - - - - - - - -
SOURCE1
SOURCE2
BOTH
*: Not shown when [BOAT TYPE] is set
to [VOLVO EVC BOAT].