2. WIRING
2.2
Processor Unit
All cables are connected in the Processor Unit. To connect the FAP-7021 and FAP-6112
to the Processor Unit directly, remove the connector at the end of their cables.
2.2.1
Connections inside the processor unit
Pins are "numbered" from left to right, in ascending order. See the inset in the figure below
for details.
TB2
(Motor/
Solenoid)
Location of jumper block J104
J104
TB13
TB8
2-2
TB13
(Remote Controller 1 and 2)
TB1
(Power)
TB10
(RRU*)
+
-
TB4
(GENERAL OUT (External buzzer, etc.))
TB3
(Bypass clutch)
TB8
(Control Unit A and B)
TB11
(CAN bus equipment)
TB12
(CAN bus power)
TB7
(IF-700IPS or
NMEA 0183 Nav equipment)
TB6
(NMEA 0183 Nav equipment)
TB5
(GENERAL IN (Event switch, etc.))
Pin arrangement
Pin no.
1 - 6
Pin no.
7 - 12
* Rudder
Reference
Unit
(Example: TB13)