Confirmation Of The Dockside Setup - Furuno NAVpilot-711C Installation Manual

3. INITIAL SETTINGS
4. Rotate the knob to set the highest speed at which power assist activates. The setting
range is 1.0 to 9.9 knots.
5. If you want power assist in the STBY mode, use the knob to set [POWER ASSIST
STBY] to [ON].
6. Use the knob to select [POWER ASSIST RUDDER SPEED] then push the knob.
1.
POWER ASSIST RUDDER SPEED
RUDDER SPEED:
TURN HELM PORT/STBD TO
SET RUDDER SPEED.
HIGHER VALUE = FASTER SPEED
PUSH MENU KEY TO CONTINUE
20 10
7. Turn the helm to port and starboard to set [POWER ASSIST RUDDER SPEED], and
then push the knob. The setting range is 1 to 10 (default setting: 10). The higher the
setting, the stronger the power assist.
3.5.4

Confirmation of the dockside setup

After entering the dockside setup, confirm that the dockside setup is completed correctly,
and the safe helm and power assist features work properly.
When the RRU is installed
• Confirmation of the rudder limit setup
1) Show the rudder angle indicator.
2) Turn the helm hard-over to port at the dockside.
3) Confirm that the rudder angle indicator shows the value set at [RUDDER LIMIT
SETUP].
4) Turn the helm hard-over to starboard at the dockside.
5) Confirm that the rudder angle indicator shows the value set at [RUDDER LIMIT
SETUP].
• Confirmation of the AUTO mode at the dockside
1) Show the rudder angle indicator.
2) Select the AUTO mode at the dockside.
3) Rotate the knob clockwise to set course.
4) Confirm that the rudder turns to starboard with the rudder angle indicator.
5) Rotate the knob counterclockwise to set course.
6) Confirm that the rudder turns to port with the rudder angle indicator.
3-16
10
5 5 10 20
Not shown in case of Fantum Feedback TM .