Rudder Reference Unit Fap-6112 - Furuno NAVpilot-711C Installation Manual

1.3

Rudder Reference Unit FAP-6112

Note 1: This unit is not required for Fantum Feedback
TM
Feedback , see "Fantum Feedback
• Leave sufficient space around all moving parts.
• The unit must be fastened to the rudder as shown below, where the following condi-
tions are met:
350 mm(13.8") <Y2 < 540 mm(21.3")
X1 = X2
Y1 = Y2
Use four self-tapping screws (supplied) to fasten the rudder reference unit.
After mounting the RRU unit adjust it as follows:
1. Center the rudder.
2. With the rudder centered, check if the notch is aligned with the arrow mark. If it is, no
further adjustment is necessary. If not, go to step 3.
3. Loosen the screw on the arm of the RRU then align notch with the arrow mark.
4. Tighten the screw.
TM
" (page 1-8).
90 degrees
RRU may be installed at
either side of rudder.
Align the notch on the shaft with
the arrow mark as shown below.
TM
. For details of Fantum
Y2
X1
°
90
Arrow
mark
Y1
RRU
Rudder
Top view
Notch
1. INSTALLATION
X2
Arrow mark
1-7