Installing The Electronic Programming Module (Epm) - BIG ASS FANS Powerfoil 8 Installation Manual

30

Installing the Electronic Programming Module (EPM)

If hanging multiple fans, ensure to install the exact EPM included in each fan's packaging. EPMs are not
interchangeable!
CAUTION: Install the EPM prior to applying power to the fan controller!
AVERTISSEMENT : Installer les MPE avant la mise sous tension du ventilateur.
applying power to the fan controller. This module is provided as part of the fan's accessory kit.
To install the EPM, disconnect the fan from power (refer to the position of the disconnect switch below). Insert the EPM in the location
shown below. Note: The EPM can only be inserted one way. Do not force it!
Electronic
Programming
Module
WWW.BIGASSFANS.COM
®
12'–24' POWERFOIL 8, 12'–24' POWERFOIL
Electrical Installation (cont.)
WARNING
DO NOT USE THIS
DISCONNECT TO
START AND STOP THE
FAN. PERMANENT
DAMAGE WILL
RESULT!
AUTO
1 2 5 6 1 2 5 6
U V W
/T1 /T2
©2012 DELTA T CORP. DBA BIG ASS FAN
®
8PLUS
SCA M E
SCA M E
FWD
RUN
REV
M
R F
STOP
25 4 11 25 4 11 13A13B13C 14 30 16 17 13A13B13C 14 30 16 17
L1
L2
PE
L1 L2 L3
/T3
L3
ALL RIGHTS RESERVED
must be installed prior to