Assembling The Front Wheel; Adjusting The Front Wheel Static Balance - Yamaha 2010 XMAX YP125R Service Manual

EAS21960

ASSEMBLING THE FRONT WHEEL

1. Install:
New
• Wheel bearings
M MMM M MMM M M MMM M
a. Install the new wheel bearing (right side).
ECA37P1029
NOTICE
Do not contact the wheel bearing inner race
"1" or balls "2". Contact should be made
only with the outer race "3".
TIP
Use a socket "4" that matches the diameter of
the wheel bearing outer race.
b. Install the spacer.
c. Install the new wheel bearing (left side).
TIP
Place a suitable washer "1" between the socket
"2" and the bearing so that both the inner race
"3" and outer race "4" are pressed at the same
time, and then press the bearing until the inner
race makes contact with the spacer "5".
M MMM M M MMM M M MMM M
L LLL L LLL L
EAS21970
ADJUSTING THE FRONT WHEEL STATIC
BALANCE
MMM
TIP
• After replacing the tire, wheel or both, the front
wheel static balance should be adjusted.
• Adjust the front wheel static balance with the
brake disc installed.
1. Remove:
• Balancing weight(s)
2. Find:
• Front wheel's heavy spot
TIP
Place the front wheel on a suitable balancing
stand.
M MMM M MMM M
a. Spin the front wheel.
b. When the front wheel stops, put an "X
at the bottom of the wheel.
c. Turn the front wheel 90° so that the "X
is positioned as shown.
d. Release the front wheel.
e. When the wheel stops, put an "X
the bottom of the wheel.
4-12
FRONT WHEEL
L LLL L L LLL L L LLL L
M MMM M M MMM M M MMM M
L LLL L LLL
M MMM M MMM
" mark
1
" mark
1
" mark at
2