Yamaha 2010 XMAX YP125R Service Manual page 229

TIP
While holding the damper rod with the damper
rod holder "2" and T-handle "3", tighten the
damper rod bolt.
Damper rod holder
90890-01294
Damping rod holder set
YM-01300
T-handle
90890-01326
T-handle 3/8" drive 60 cm long
YM-01326
3
4. Install:
• Oil seal "1" New
(with the fork seal driver weight "2" and fork
seal driver attachment "3")
Fork seal driver weight
90890-01367
Replacement hammer
YM-A9409-7
Fork seal driver attachment (ø38)
90890-01372
Replacement 38 mm
YM-A5142-1
ECA14220
NOTICE
Make sure the numbered side of the oil seal
faces up.
TIP
• Before installing the oil seal, lubricate its lips
with lithium-soap-based grease.
• Lubricate the outer surface of the inner tube
with fork oil.
• Before installing the oil seal, cover the top of
the front fork leg with a plastic bag to protect
the oil seal during installation.
1
2
4-54
5. Install:
• Oil seal clip "1"
TIP
Adjust the oil seal clip so that it fits into the outer
tube's groove.
6. Install:
New
• Dust seal "1"
(with the fork seal driver weight "2")
Fork seal driver weight
90890-01367
Replacement hammer
YM-A9409-7
FRONT FORK