Instrument Functions - Yamaha 2010 XMAX YP125R Service Manual

Immobilizer system keys may cause signal inter-
ference, which may prevent the engine from
starting.
2. If the engine starts, turn it off, and try starting
the engine with the standard keys.
3. If one or both of the standard keys do not start
the engine, re-register the standard keys.
If the multi-function display indicates any fault
codes, note the code number, and then check
the vehicle.
Refer to "IMMOBILIZER SYSTEM" on page
8-61.
Clock mode
To set the clock:
1. Push the "SELECT" button and "RESET" but-
ton together for at least two seconds.
2. When the hour digits start flashing, push the
"RESET" button to set the hours.
3. Push the "SELECT" button, and the minute
digits will start flashing.
4. Push the "RESET" button to set the minutes.
5. Push the "SELECT" button and then release
it to start the clock.
Ambient temperature display
Pushing the "SELECT" button for at least two
seconds switches the clock display to the ambi-
ent temperature display. This display shows the
ambient temperature from -10 °C to 50 °C in 1
°C increments. The temperature displayed may
vary from the ambient temperature. Pushing the

INSTRUMENT FUNCTIONS

"SELECT" button for at least two seconds
switches the ambient temperature display to the
clock display.
TIP
• If the ambient temperature falls below -10 °C,
a lower temperature than -10 °C will not be dis-
played.
• If the ambient temperature climbs above 50 °C,
a higher temperature than 50 °C will not be dis-
played.
• The accuracy of the temperature reading may
be affected when riding slowly (approximately
under 20 km/h (12.5 mi/h)) or when stopped at
traffic signals, railroad crossings, etc.
1-7