Installing The Front Brake Master Cylinder - Yamaha 2010 XMAX YP125R Service Manual

Mbk skycruiser
Hide thumbs Also See for 2010 XMAX YP125R:
Table of Contents

Advertisement

EAS22530
INSTALLING THE FRONT BRAKE MASTER
CYLINDER
1. Install:
• Brake master cylinder "1"
• Brake master cylinder holder
Brake master cylinder holder bolt
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
TIP
• Align the projection "a" on the brake master cyl-
inder with the hole "b" in the handlebar.
• First, tighten the front bolt, then the rear bolt.
b
2. Install:
• Copper washers "1"
• Front brake hose "2"
• Brake hose union bolt "3"
Brake hose union bolt
23 Nm (2.3 m·kgf, 17 ft·lbf)
EWA37P1024
WARNING
Proper brake hose routing is essential to in-
sure safe vehicle operation. Refer to "CABLE
ROUTING (YP125R)" on page 2-29 and "CA-
BLE ROUTING (YP250R)" on page 2-75.
ECA14160
NOTICE
When installing the brake hose onto the
brake master cylinder, make sure the brake
pipe touches the projection "a" as shown.
TIP
Turn the handlebar to the left and right to make
sure the brake hose does not touch other parts
(e.g., wire harness, cables, leads). Correct if
necessary.
1
a
New
New
1
3. Fill:
• Brake master cylinder reservoir
(with the specified amount of the recom-
mended brake fluid)
Recommended fluid
DOT 4
EWA13540
WARNING
• Use only the designated brake fluid. Other
brake fluids may cause the rubber seals to
deteriorate, causing leakage and poor
brake performance.
• Refill with the same type of brake fluid that
is already in the system. Mixing brake fluids
may result in a harmful chemical reaction,
leading to poor brake performance.
• When refilling, be careful that water does
not enter the brake master cylinder reser-
voir. Water will significantly lower the boil-
ing point of the brake fluid and could cause
vapor lock.
ECA13540
NOTICE
Brake fluid may damage painted surfaces
and plastic parts. Therefore, always clean up
any spilt brake fluid immediately.
4. Bleed:
• Brake system
Refer to "BLEEDING THE HYDRAULIC
BRAKE SYSTEM" on page 3-36.
5. Check:
• Brake fluid level
Below the minimum level mark "a" → Add the
recommended brake fluid to the proper level.
Refer to "CHECKING THE BRAKE FLUID
LEVEL" on page 3-35.
4-27
FRONT BRAKE
a
2
3

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

2010 xmax yp250rXmax 125Xmax yp125rXmax yp125ra

Table of Contents