Installing The Fuel Tank - Yamaha 2010 XMAX YP125R Service Manual

Pressure gauge
90890-03153
YU-03153
Fuel pressure adapter
90890-03181
3
2
c. Start the engine.
d. Measure the fuel pressure.
Output pressure
250.0 kPa (2.50 kgf/cm², 36.3
psi)
Faulty → Replace the fuel tank (with fuel
pump).
e. Connect the fuel hose and install the fuel
hose connector cover.
Refer to "INSTALLING THE FUEL TANK" on
page 7-4.
L LLL L LLL L L LLL L
EAS37P1072

INSTALLING THE FUEL TANK

1. Install:
• Gasket New
• Fuel sender "1"
TIP
Install the fuel sender with the fuel sender
wrench "2".
Fuel sender wrench
90890-11098
2
1
4
L LLL L L LLL L L LLL L
2. Install:
• Fuel hose
• Fuel hose connector cover
ECA37P1022
NOTICE
When installing the fuel hose, make sure that
it is securely connected, and that the fuel
hose connector cover is in the correct posi-
tion, otherwise the fuel hose will not be prop-
erly installed.
TIP
• Wipe up any fuel remaining in the recess "a" in
the fuel pump with a dry rag "1".
• After installing the fuel hose connector cover
"2", make sure that it is installed securely.
LLL
7-4
FUEL TANK
1
a
2