Checking The Exhaust System; Checking The Coolant Level - Yamaha 2010 XMAX YP125R Service Manual

1
3. Install:
• Storage box
Refer to "GENERAL CHASSIS" on page 4-1.
EAS21080

CHECKING THE EXHAUST SYSTEM

1. Check:
• Exhaust pipe "1"
• Muffler "2"
Cracks/damage → Replace.
• Exhaust system connection
Exhaust gas leaks → Replace the gasket "3".
2. Check:
• Tightening torque
Exhaust pipe nut
20 Nm (2.0 m·kgf, 14 ft·lbf)
Muffler joint bolt
14 Nm (1.4 m·kgf, 10 ft·lbf)
Muffler mounting bolt
65 Nm (6.5 m·kgf, 47 ft·lbf)
O sensor
2
45 Nm (4.5 m·kgf, 32 ft·lbf)
2
EAS21110

CHECKING THE COOLANT LEVEL

1. Stand the vehicle on a level surface.
TIP
• Place the vehicle on the centerstand.
• Make sure the vehicle is upright.
2. Check:
• Coolant level
ECA37P1019
NOTICE
•Adding water instead of coolant lowers the
antifreeze content of the coolant. If water is
used instead of coolant, check, and if nec-
essary, correct the antifreeze concentra-
tion of the coolant.
•Use only distilled water. However, if distilled
water is not available, soft water may be
used.
3-31
ENGINE (YP250R)
2
The coolant level should be between the
maximum level mark "a" and minimum level
mark "b".
Below the minimum level mark → Add the
recommended coolant to the proper level.
3
3
1