miniature aircraft Fury 55 X-CELL Assembly Instructions Manual page 41

0133-1
120-25
0133-1
Illustration 6g
Locate the two MA120-25 m3x86 threaded control rod, two MA0053-5 m3x16 socket set screws (these will be used as a threaded control
rod), and four MA0133-1 plastic grey ball links. Refer to Illustration 6g for this step. Use the MA120-25 m3x86 threaded control rods,
and MA0331-1 plastic grey ball links to make two "Hiller" control rods. These control rods should be made so that 70mm of thread
control rod is visible between the ball links. See page 44 for control rod lengths. Use the MA0053-5 m3x16 socket set screws, and
MA0133-1 plastic grey ball links to make two "Bell" control rods. These control rods should be made so that 0.0mm of thread control rod
is visible between the ball links. See page 44 for control rod lengths. Install the completed control linkages as shown in the illustration.
3700-150
USED onLy
foR 12MM
BLADE RooTS
MAIn BLADE
Illustration 6h
Locate two MA0082 m4x38 socket bolts, two MA0021 m4 locknuts, four MA3700-150 1mm main rotor blade mount spacers, and the rotor blades
you intend to use for this model. Refer to Illustration 6h for this step. NOTE: The main rotor blade grips on the Fury 55 have a 14mm grip spacing.
Some rotor blades have a 12mm root thickness. If this is the case with your rotor blades, please use the MA3700-150 1mm main rotor blade mount
spacers above and below each rotor blade root. If your rotor blades have a 14mm root thickness, do not use the spacers. Install the MA0082 m4x38
socket bolt through the hole in the blade grip, and through the rotor blades, and attach the MA0021 m4 locknut on the bottom. Main rotor grip
tightness should be so that the blades do not "fall under their own weight", but can still be rotated in the mount with moderate force.
0082
0021
41
0133-1
0053-5
0133-1
0082
3700-150
2 PER SIDE
0021